IC MCT2E DATASHEET PDF

MCT2 and MCT2E are also available in white package by . MCT2E. MCT2E-M. MCT V. (IC = 16 mA, IF = 32 mA, TA = °C). Details, datasheet, quote on part number: MCT2E Collector-emitter saturation voltage Input-to-output internal resistance TEST CONDITIONS = 10 µA, IC =1. MCT2E ON Semiconductor / Fairchild Transistor Output Optocouplers DIP-6 PHOTO TRANS datasheet, inventory & pricing.

Author: Fecage Arataxe
Country: Turkmenistan
Language: English (Spanish)
Genre: Video
Published (Last): 23 October 2009
Pages: 122
PDF File Size: 16.66 Mb
ePub File Size: 18.38 Mb
ISBN: 624-5-43293-349-6
Downloads: 85821
Price: Free* [*Free Regsitration Required]
Uploader: Arat

This is the logic output pin 6 Base B Base pin of the Transistor. Submitted by admin on 7 March The Mcct2e pin 4 is grounded.

The complete working can also be understood form the GIF file above. This comes in very handy when you are trying to isolate a noisy signal from your digital electronics, so if you are looking for an IC to provide optical isolation in your circuit design then this IC might be the right choice for you.

When the IR led is powered the light from it falls on the transistor and it conducts. Another important parameter to consider while using an Optocoupler, is the rise time tr and fall time tf.

  MANUAL DIALUX 4.8 PDF

Connected to isolated ground. The below waveform shows the time taken for the output to transit from one state to another.

It is normally not used for dahasheet mode, but will be used in diode mode.

IC MCT2E Optocouplers, datasheet and pin description.

This IC is used to provide electrical isolation between two circuits, one part of the circuit is connected to datasheft IR LED and the other to Photo-transistor. This way the logic input will be reflected at the logic output and still provides and isolation between the two. Out of which the Phototransistor mode is mostly used, so let us look at that mode first.

This is where the isolation occurs. In the Photo-transistor mode we will not be using the base pin pin 6 of the transistor; we just have to connect the anode pin of the IR LED pin 1 to the logic input which has to be isolated and the cathode pin 2 of the IR led to the ground.

Base pin of the Transistor. Then Pull high the collector pin of the transistor using a resistor here I have used 1K and connect the collector pin to the output of your desired logic circuit.

  JA TO MOGU LUJZA HEJ PDF

The ground line of the IR LED pin 2 and the ground line of the transistor pin 4 will not be connected together. The digital signal given to the IR LED will be reflected on the transistor but there will be no hard electrical connection between the two.

This will short the collector and emitter and datadheet the Logic Output voltage will become zero.

The output will not get high as soon as the input logic is made low and vice versa. TL — Programmable Reference Voltage.

IC MCT2E Optocouplers

But when the Logic input is made high, this high voltage should be a minimum of 1. More details can be found at the MCT2E datasheet which is available for download at the end of this page.

There pull-up resistor 1K acts as a load resistor.